Installing the DSPlink 1.40.05 archive#
To install the DSPlink archive:
- Install the BSP using setupbsp and specifying the path of installation.
- Extract the DSPlink archive into the root of where the BSP is installed.
- Navigate to the root of the BSP directory.
- Run the setenv.sh script to set up the installation directory for the DSPlink components without affecting the BSP:
- Run make install to compile the BSP and DSPlink.
Installing the DSPlink 1.6.x archive#
Requirements
- QNX SDP 6.4.0
- Jacinto BSP 1.0.0 for 6.4.0 or Jacinto-DDR BSP
- Updated startup-jacinto
- Dsplink 1.6.x archive
To install the updated startup files (required if using Jacinto BSP 1.0.0 from Oct 31, 2008)
- Contact your Support or Sales representitive to retrieve the updated startup files or get files from Trunk BSP bsp-ntotrunk-ti-dra446-evm-trunk.zip
- The following files have been updated: 'build', 'init_intrinfo.c', and 'main.c'
- Copy the updated files to the startup folder of the BSP directory (<install_dir>/src/hardware/startup/boards/jacinto/)
- Rebuild startup
To install the DSPlink archive:
- Install the 6.4.0 Jacinto BSP by extracting to the directory of your choice
- Extract the Dsplink archive into the root of where the BSP is installed or a directory of your choice
- Navigate to the installation directory
- Run the setenv.sh script to set up the installation directory for the Dsplink components without affecting the BSP
- Run make install to compile the DSPlink and the BSP.