Hugh Brown
|
Re: realtek 8169 second ethernet port failure to init
|
Hugh Brown
01/03/2017 8:21 AM
post117299
|
Re: realtek 8169 second ethernet port failure to init
Hello Jesus,
If you slay Net and Net.rtl8169, and then run ³Net &² followed by
³Net.rtl8169 -I1 &², does the second interface come up? It is strange that
the tcrval for the second interface is not the same as the first interface.
Thanks, Hugh.
On 2017-01-02, 6:59 PM, "Jesus Gomez" <community-noreply@qnx.com> wrote:
>Hello Hugh,
>
>I'm running the latest Oct 30 2014 release of Net.rtl8169 and Net.
>
>Photon runs ok and network port 1 runs Ok as well, so far with the TCP/IP
>stack.
>
>System has a VGA and VDI port, but we are using the VGA port only. We
>have made BIOS change for only VGA mode.(IGD and CRT settings). USB
>keyboard and mouse works.
>
>However system complaints at initialization before the graphics
>environment loads, I have traced back to have a minimal system running
>with Net and Net.rtl8169, port 2 (PCI-1) always fails to initialize.
>System indicates is a RTL8111E-VB-CG x 2 gigabit ethernet chipset.
>
>I'm including screenshots of the system.
>
>Could you help us please, this is a prototype system for production.
>
>Regards,
>
>Jesus Gomez
>AMI GE
>
>
>
>
>_______________________________________________
>
>General
>http://community.qnx.com/sf/go/post117298
>To cancel your subscription to this discussion, please e-mail
>general-qnx4-unsubscribe@community.qnx.com
|
|
|