Hello, On two systems (QNX 6.4.1 on MPC8245 and MPC8548) I notice the following problem. If I start the speedo diver like this it works: io-pkt-v4-hc -dspeedo -ptcpip But if I tried to start it in two times: io-pkt-v4-hc -ptcpip mount -T io-pkt devnp-speedo.so Then it failed. There is no message but io-pkt was killed. Any idea? Christophe
I'll have to setup a system some time and try this out. -----Original Message----- From: Christophe Hannoyer [mailto:community-noreply@qnx.com] Sent: Thursday, October 15, 2009 6:11 AM To: drivers-networking Subject: io-pkt, speedo and mount Hello, On two systems (QNX 6.4.1 on MPC8245 and MPC8548) I notice the following problem. If I start the speedo diver like this it works: io-pkt-v4-hc -dspeedo -ptcpip But if I tried to start it in two times: io-pkt-v4-hc -ptcpip mount -T io-pkt devnp-speedo.so Then it failed. There is no message but io-pkt was killed. Any idea? Christophe _______________________________________________ Networking Drivers http://community.qnx.com/sf/go/post40004