Christian Damus(deleted)
|
Re: Build variant PPC (Big Endian SPE)
|
Christian Damus(deleted)
09/10/2009 1:05 PM
post37763
|
Re: Build variant PPC (Big Endian SPE)
Hi, Christophe,
This is almost certainly a bug in the IDE. I shall raise it internally
in our tracking system and report back when I have an update.
Cheers,
Christian
On Thu, 2009-09-10 at 12:55 -0400, Christophe Hannoyer wrote:
> Hello,
>
> I get a problem when using the IDE 4.6.0 (QNX 6.4.1 including now the new variant for PPC BE SPE) when I try to setup
a new "QNX System Builder Project". Then I select "Create Generic" and select "ppcspe". When the project was create if
now I tried to add new binaries for example in this project the list is empty. If I do the same with for example ppcbe
and try to include new binaries I get a list of files from $QNX_TARGET/ppcbe/...
>
> In the image properties I can see that the "CPU Type" was set to "ppcspe" and if I look in the directory $QNX_TARGET/
there is no ppcspe directory but a ppcbe-spe.
>
> For a test only I rename the directory $QNX_TARGET/ppcbe-spe to $QNX_TARGET/ppcspe and then the list of binaries was
there.
>
> After doing all these changes I can build and use the image.
>
> Is there someone else with experiences with this issue?
>
> Thank you,
> Christophe
>
>
>
> _______________________________________________
>
> General
> http://community.qnx.com/sf/go/post37760
>
________________________________________________________________________
Christian W. Damus
Software Developer, IDE Team
QNX Software Systems
|
|
|
Christian Damus(deleted)
|
Re: Build variant PPC (Big Endian SPE)
|
Christian Damus(deleted)
01/19/2010 11:27 AM
post45496
|
Re: Build variant PPC (Big Endian SPE)
Hi, Christophe,
This problem is fixed in the current development stream. The fix will be available in the IDE 4.7 release (SDP 6.4.2).
Cheers,
Christian
|
|
|