Why it is an IDE problem? Can you ping it? If not you did not start 
network drivers or it is not configured.
If you mean you cannot connect with IDE you have to start "qconn" 
process on target to connect

On 22/02/2011 5:04 PM, Mark Bangert wrote:
> I'm new to the QNX IDE.  So far I've successfully created a project and built it for an ARM device.  I have been able 
to load the kernel into the target over the serial port and start it.  The problem is, I can't get a network connection 
over the network.  I suppect its a Windows 7 thing.  I shut off all of my firewalls but still can't connect.
>
> Has anyone had this issue and how do you work around it???
>
>
>
> _______________________________________________
>
> General
> http://community.qnx.com/sf/go/post83393
>