foundry27 : Post

Forum Topic - Setting the speed of the ethernet interfaces: (2 Items)

View: as

Robert Deschambault

09/29/2008 10:19 AM

post14176

Setting the speed of the ethernet interfaces

Hi,

I have an SBC which supports 10/100/1000 ethernet speeds which is connected to a Cisco network switch which is expecting
 an interface setup to autonegotiate at the above speeds.

I have been told that our QNX setup is currently configured to 10/100, not to 10/100/1000.  How can I confirm this and 
what tools are used to permanently configure this?

Thanks.

Bob

Robert Craig

09/29/2008 10:34 AM

post14180

RE: Setting the speed of the ethernet interfaces

This question would be best answered in the Network Driver forum.
Please post information about the hardware platform and NIC card /
driver being used.

http://community.qnx.com/sf/discussion/do/listForums/projects.networking
/discussion

	Robert.

-----Original Message-----
From: Robert Deschambault [mailto:community-noreply@qnx.com] 
Sent: Monday, September 29, 2008 10:20 AM
To: osmeta-core_os
Subject: Setting the speed of the ethernet interfaces

Hi,

I have an SBC which supports 10/100/1000 ethernet speeds which is
connected to a Cisco network switch which is expecting an interface
setup to autonegotiate at the above speeds.

I have been told that our QNX setup is currently configured to 10/100,
not to 10/100/1000.  How can I confirm this and what tools are used to
permanently configure this?

Thanks.

Bob

_______________________________________________
OSMeta
http://community.qnx.com/sf/go/post14176

Return

The text you entered is not a valid object ID
More Information
Object IDs begin with an object prefix and end with a number. For example, if you enter
artf2345
the application will jump directly to an artifact with the ID artf2345. Some valid object prefixes are:
artf	for an artifact
doc	for a document
page	for a project page
topc	for a discussion topic
wiki	for a wiki page