Hi,

This is the first time I am using the QNX Rtos. I have got non-commercial licence and followed all the steps to install 
SDP 6.6 and app and Media 1.1. I have also downloaded the reference QNX images for my OMAP5 EVM hardware.

But when I run this image from SD card boot on OMAP5, I get below output.

PU AVS 0: disabled.                                                                 
MM AVS 0: disabled.                                                                  
CORE AVS 0: disabled.                                                                
MPU ABB: disabled.                                                           
MM ABB: disabled.                                                            
CORE ABB: disabled.                     
                                        
Found OMAP5432 ES2.0 SoC                
QNX Neutrino Initial Program Loader for OMAP5 uEVM
Booting from SD card                    
Loading QNX image from SD...            
Load QNX image from SDMMC...
Found image        @ 0x8C900008
Jumping to startup @ 0x801063F4

Starting SD Card as system disk /dev/sysdisk0 (eMMC will be /dev/emmc0)...
Starting eMMC disk at /dev/emmc0...
Starting SATA at /dev/satadrive0...
Starting tiler...
Waiting for tiler before starting screen...
configured grow size is 16
configured grow size is 16
Tiler ready!
Starting slogger
Starting dumper
Waiting for disk before starting screen...
Starting screen.
sourcing env.sh
Starting UART1 (Console)
Starting SLM...
Starting RTC utility...
RTC is stopped.  Enabling RTC.
# 

After the # I don't see anything happing on the mincom. I don't see any basic HMI screen. Please guide me what is going 
wrong.

I have not yet installed QT or HTML5. Do I need to install that?

Regards,
Archana
archana.gondane@sasken.com