Hello,

  I have just started out using QNX from being used to Linux, so excuse me if this question is basic. I need to get some
 USB support added on to our BSP. I am wondering how this works in QNX ? For example, in Linux, there is some generic 
USB support code and then some specific driver code for the particular US chip in question which implements some of the 
generic USB APIs. Does it work the same way in QNX too?

Where can I download USB code for QNX? The specific USB chip whose driver I'm looking for is a Phillips NXP ISP-1161-
A1BD. Does anyone have drivers for this specific chip?

A general informative link on porting USB drivers to QNX would also be appreciated.

Thanks so much in advance.