|
Raja Naeem(deleted)
|
Re: Hhow to make Bootable USB of QNX OS
|
|
Raja Naeem(deleted)
11/01/2017 1:37 PM
post118171
|
Re: Hhow to make Bootable USB of QNX OS
Sir first of all thank you so much for replying.
Sir I'm using SanDisk Ultra USB 3.0 (14 Gigabyte Memory) to install QNX 4.25 ISO file on PXIe-8130 Embeded controller
using PXIe-1071 Chassis. I made QNX 4.25 ISO file using MagicISO software and then I made USB Bootable using XBoot
Software. I tried other softwares (i.e. UltraISO, Rufus, PowerISO etc.) to make it Bootable but it always failed, Only
XBoot did it successfuly.
Now, when I plug-in USB and Boot system from USB, it stops just after a few initial steps, means, Screen shows option to
select Operating System to be installed. QNX 4.25 is also showed there. When I click on it, it simply hangs up there
and following message is shown on screen:
"B kbd Unable to open system initialization file: corrupted file system detected"
I am in doubt that may be I'm committing some mistake in making USB Bootable.
Please guide me in the light of your greater experience please.
Thanks in advance.
|
|
|
|
|
|
Raja Naeem(deleted)
|
Re: Hhow to make Bootable USB of QNX OS
|
|
Raja Naeem(deleted)
11/01/2017 1:39 PM
post118172
|
Re: Hhow to make Bootable USB of QNX OS
Sir first of all thank you so much for replying.
Sir I'm using SanDisk Ultra USB 3.0 (14 Gigabyte Memory) to install
QNX 4.25 ISO file on PXIe-8130 Embeded controller
using PXIe-1071 Chassis. I made QNX 4.25 ISO file using MagicISO
software and then I made USB Bootable using XBoot
Software. I tried other softwares (i.e. UltraISO, Rufus, PowerISO
etc.) to make it Bootable but it always failed, Only
XBoot did it successfuly.
Now, when I plug-in USB and Boot system from USB, it stops just after
a few initial steps, means, Screen shows option to
select Operating System to be installed. QNX 4.25 is also showed
there. When I click on it, it simply hangs up there
and following message is shown on screen:
"B kbd Unable to open system initialization file: corrupted file
system detected"
I am in doubt that may be I'm committing some mistake in making USB Bootable.
Please guide me in the light of your greater experience please.
Thanks in advance.
On Wed, Nov 1, 2017 at 7:04 PM, Albrecht Uhlmann <community-noreply@qnx.com>
wrote:
> Hello Raja,
> my guess is that the boot image on USB disk is located somewhere in a
> region on the disk that is not accessible by QNX 4 boot loader. Mayb try a
> real old fashined stick of 512 MB or so?
>
> Regards,
> Albrecht
>
>
>
> _______________________________________________
>
> QNX Momentics Getting Started
> http://community.qnx.com/sf/go/post118168
> To cancel your subscription to this discussion, please e-mail
> momenticsgs-community-unsubscribe@community.qnx.com
>
|
|
|
|
|
