Lisa Damodaran
|
Launching serial debugger failed
|
Lisa Damodaran
11/02/2011 5:23 AM
post89820
|
Launching serial debugger failed
Hi
I am new to QNX and MOMENTICS IDE. I am trying to debug a "simple hello world" program in the AM3517 EVM target using
the serial debug. But I am getting errors as attached.
I am booting the target using TFTP boot option and all the drivers are available. I am trying to debug once the target
is up and running. Pdebug is available and serial driver is also invoked.
Is the procedure correct? Please help...
Thanks
Lisa
________________________________
::DISCLAIMER::
-----------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended for the named recipient(s) only.
It shall not attach any liability on the originator or HCL or its affiliates. Any views or opinions presented in
this email are solely those of the author and may not necessarily reflect the opinions of HCL or its affiliates.
Any form of reproduction, dissemination, copying, disclosure, modification, distribution and / or publication of
this message without the prior written consent of the author of this e-mail is strictly prohibited. If you have
received this email in error please delete it and notify the sender immediately. Before opening any mail and
attachments please check them for viruses and defect.
-----------------------------------------------------------------------------------------------------------------------
|
|
|