Nikolsky Oleg(deleted)
|
Can't install selfhosted QNX 6.4.1 on PC
|
Nikolsky Oleg(deleted)
11/27/2009 9:38 AM
post42735
|
Can't install selfhosted QNX 6.4.1 on PC
I am trying to install QNX 6.4.1 on PC with motherboard GIGABYTE GA-M61PME-S2
(http://europe.giga-byte.com/FileList/Manual/motherboard_manual_ga-m61pme-s2_rev.2.0_e.pdf).
PC is equipped with SATA hard disk. Fedora 12 Lynux installed in first 30 Gb of disk, next 5 GB free space for QNX
partition.
1) After I select "Install to hard drive" option installer writes on screen:
...
Trying SATA ahci. Scanning for devices...
xpt_configure: ahci SIM attach failure
Trying EIDE. Scanning for devices...
... found 2 devices
Detected USB. Scanning for devices...
...found 4 devices
Trying SATA mvSATA. Scanning for devices...
xpt_configure: No mvSATA devices found.
Started installation is interrupted with message on screen:
"unable to access /dev/hd0t179
Mounting filesystems...
Partition installation aborted!
Please remove the installation media, then reboot your machine"
It is interesting that QNX file system is created on hard drive when I look at disk partitions using disk partition tool
after reboot.
2) If I select "boot from CD" option, QNX starts normal, but no hard drive is mounted under /fs directory, only cd0.
Also "hd0 488,395,055" is located in /dev directory. Utility hw_info_script output file attached.
My first question: How can I install QNX on this PC or it is impossible?
My additional question: Is there any AMD x86 processor that QNX Neutrino consider to be multycore? My "AMD AthlonTM 64
X2 4400+ dual-Core processor" QNX descryies as single core processor when boot from CD, though there is procnto-smp
kernel image in /boot/sys/ directory.
|
|
|