Jeevan Mathew(deleted)
|
AW: connecting to target board
|
Jeevan Mathew(deleted)
05/09/2008 5:13 AM
post7911
|
AW: connecting to target board
As long Your target is supported You need to make sure that You run
------
devc-pty
io-net .... //network must be up
..
...
qconn
-------
On Your target .
This will make You able to connect to Your Momentics IDE.
For a sample x86 buildfile what makes an x86 target connectable with
Your IDE try that x86ph.build from post7240.
Once the target runs.....
On Your Momenticcs IDE side do:
Window -> Show View -> Other ... -> QNX Targets -> choose the "Target
Navigator" View
say ok.
Right click into that view and add a new target.
Jeevan
-----Ursprüngliche Nachricht-----
Von: murugadoss v [mailto:v.murugadoss@gdatech.co.in]
Gesendet: Freitag, 9. Mai 2008 10:53
An: momentics-community
Betreff: connecting to target board
hi,
I am new user of QNX . I had got the qnx momentics ( evaluation version).
*My question, is it possible to connect the target board with this version*?
if it is possible please tell how to do it.
By referring the online document, i understood there is need for qnx
neutrino rtos ( for Qconn facility).
Thank u
--
*/Regards,/*
/V.Murugadoss,
/
-------------------
We recently installed the spam filter from Abaca. It's over 99% accurate.
Check it out - http://www.abaca.com/success/story.cgi?domain=gdatech.co.in
-------------------
_______________________________________________
QNX Momentics Community Support
http://community.qnx.com/sf/go/post7909
|
|
|