Hello,

I have a MIPSLE card running on QNX 6.4.1. The network driver is an io-net driver which is run using devn-shim (shim 
layer) with io-pkt-v4. I do not see any problems while loading the network drivers and there are no problems with 
assigning IP addresses as well. 

But when I start qconn and try to see the folder structure on IDE, then I can only see the folders but not the files 
present in the folders. 

The same board was earlier running on 6.2.1 and it did not have any problem then. I am wondering if this is a network 
driver issue.

Regards
Sunil