rohitha vakamudi
|
Re: Welcome to the QNX Momentics Community Support Forum !
|
rohitha vakamudi
07/06/2012 3:55 AM
post94111
|
Re: Welcome to the QNX Momentics Community Support Forum !
I am unable to see my connected target in momentics IDE,i cna telnet from cmd line also ping it ,but i cannot see it in
device perspective of momentics.When i try to add it,it says it already exits,but i can't see it.
|
|
|
rohitha vakamudi
|
Re: Welcome to the QNX Momentics Community Support Forum !
|
rohitha vakamudi
07/06/2012 3:59 AM
post94112
|
Re: Welcome to the QNX Momentics Community Support Forum !
> Welcome to the QNX Momentics Community Support Forum !
>
> Use this forum to post questions, raise issues, propose enhancements and read
> announcements related to QNX Momentics.
>
> For installation or entry-level questions, please use the QNX Momentics
> Getting Started forum found in the Community project.
>
> For question about technologies developed as part of a Foundry27 project,
> please refer to that project's own forums.
>
>
> - The QNX Community Management Group (QCMG)
when I compile my QNX c/c++ projects I see two different icons for the generated binaries,please refer to the attached
image.Could you explain what is the difference between these two icons
|
|
|