Please try the attached driver and let me know if it works. You
shouldn't need any command line arguments.

Thanks, Hugh.


-----Original Message-----
From: Pavel Ustinov [mailto:community-noreply@qnx.com] 
Sent: Tuesday, June 09, 2009 3:44 AM
To: qnx4-community
Subject: Problem with RTL8168 Network card driver

Hi!

I tried to use new Net.rtl8169 driver with my onboard Network card
(motherboard ASRock ConRoe1333-DVI/H), and my approach failed.
Driver I used is from topic
(http://community.qnx.com/sf/discussion/do/listPosts/projects.community/
discussion.qnx4_community_support.topc2891)
I started:
Net &
Net.rtl8169 -d 8168 -v -V 10ec &
But nothing happened.
Net.rtl8169 Run and Done ...

I tried different combination of parameters (irq, port, pci index), but
nothing helped.

That is my:
#show_pci -v

Vendor ID      = 10ech, 
Device ID      = 8168h, 
PCI index      = 0h
Class Code     = 020000h Network (Ethernet) ProgIF=0
Revision ID    = 2h
Bus number     = 1
Device number  = 0
Function num   = 0
Status Reg     = 10h
Command Reg    = 7h
Header type    = 0h Single-function
BIST           = 0h Build-in-self-test not supported
Latency Timer  = 0h
Cache Line Size= 8h un-cacheable
Base Address   = IO@e800h length 256 bytes
MEM@fdeff000h,Prefetchable,64bit length 4096
MEM@fdee0000h,Prefetchable,64bit length 65536
Subsystem Vendor ID = 1849h
Subsystem ID        = 8168h
Expansion ROM  = febf0000h  length 65536 disabled
Max Lat        = 0ns
Min Gnt        = 0ns
PCI Int Pin    = 1, INT A
Interrupt line = 10

How can I start driver?

Thanks in advance

_______________________________________________
QNX4 Community Support
http://community.qnx.com/sf/go/post31181