Mario,

Please can you send me the full "show_pci -v" output from the IBM
machine with that adapter installed?

Thanks, Hugh.


-----Original Message-----
From: Mario Charest [mailto:community-noreply@qnx.com] 
Sent: Monday, August 25, 2008 2:59 PM
To: qnx4-community
Subject: Re: RE: RE: RE: RE: Net.i82540....

> Please give this one a try. It works with my 0x10b9 device.
> 
> Hugh.

Hello Hugh,

I finally figured out that it doesn't work on a particular model of IBM.
I take the same NIC and move it around from PC to PC and only on IBM
x3650 does it fail. 

I can see it with show_pci so it's detected.  What i'm not sure about is
if the card is enable, its status is 0x10 and the command register is
0x147 (maybe 0x157 not sure)  

_______________________________________________
QNX4 Community Support
http://community.qnx.com/sf/go/post12393

Hi Dodis,

I do not know which version of install CD you are using, but if you read back through this thread you'll see that Net.
i82540 has been replaced by Net.e1000..  If you are using the 2011 CD or later then you should have the Net.e1000 driver
 already installed on your system.  If not, you  can get the latest Net.e1000 (or any other newer drivers that are 
available)  from this page:  http://community.qnx.com/sf/wiki/do/viewPage/projects.qnx4/wiki/LatestSoftwareUpdates  
which might be a good idea to get even if you do have the 2011 CD installed.  Note: If you don't have 2011 CD installed 
and you just get the latest driver, you will not have updated versions of some network utilities ... the versions you 
have will not recognize this driver.  I don't know the exact list , but remember reading about a utility that needed 
updating in this thread.

Also if you don't see the info you want when running a driver with "-v"  add more v's... i.e. "-vvvv"... the more v's 
you add the more info you get (up to a point).

-Martin.

 

-----Original Message-----
From: dodi sunardi [mailto:community-noreply@qnx.com] 
Sent: Wednesday, March 23, 2016 12:07 AM
To: qnx4-community <qnx4-community@community.qnx.com>
Subject: Re: RE: RE: RE: RE: Net.i82540....

hallo,
i have a network card with intel chipset 82540, than i found the driver Net.i82540, but that driver look like not 
working properly, because usually if i use command Net.i82540 -v & , its should be come out the list of hardware like  
mac address number and other, but in this case it is not coming out and i need the mac address to setting the network.
is any body  have a problem solving for my problem.
thanks
dodi s



_______________________________________________

QNX4 Community Support
http://community.qnx.com/sf/go/post116007
To cancel your subscription to this discussion, please e-mail qnx4-community-unsubscribe@community.qnx.com