This sounds as though the node is looking for something on the network.
Are you using Fleet networking, and if so, does the node rely on other
resources on the network?


-----Original Message-----
From: Kevin Miller [mailto:kevin.miller@transcore.com] 
Sent: Friday, June 06, 2008 4:27 PM
To: qnx4-community
Subject: QNX 4.25 commands hang before exiting

We have a system in the field that shows a symptom that I have not seen
before. If I type a command, e.g. "sin", the command executes
immediately; however, after the list of processes has been printed,
there is a long period, perhaps 15 to 20 seconds, where nothing happens
before the command prompt returns. Other commands, such as "ls", behave
similarly. It seems that something is holding up the command's exit, but
what it is is hard to say.

If anyone has any insight into this, I'd appreciate hearing about it.

Thanks,

Kevin

_______________________________________________
QNX4 Community Support
http://community.qnx.com/sf/go/post8853

This turned out to be a hardware problem.