thanks for ur valuable suggestion,nw i am able to connect.thank u.

On 10/4/12, Pooja Chahal <ece2908222@gmail.com> wrote:
> please tell me how to make phrelay enable in inetd.conf.
> I am using line mentioned below to configure phindows on QNX neutrino host.
> phrelay stream tcp nowait root /usr/bin/phrelay phrelay -x
>  and " phrelay 4868/tcp" for TCP/IPconnection.
>
>
> On 10/3/12, Max Feil <community-noreply@qnx.com> wrote:
>> Is phrelay configured to run on the (virtual) host with that ip address?
>> You
>> need to enable it in inetd.conf if you want phrelay to start
>> automatically.
>> There is a sample phrelay line commented out in inetd.conf.
>>
>> -----Original Message-----
>> From: pooja chahal [mailto:community-noreply@qnx.com]
>> Sent: Wednesday, October 03, 2012 9:44 AM
>> To: qnx4-community
>> Subject: problem in launching remote photon
>>
>> I am currently working with QNX 6.5.0 version,i am using self hosted QNX
>> Neutrino RTOS on VMwareplayer  3.0.0 version.I am facing problem in
>> launching remote photon.I am trying to connect with phindows from IDE
>> using
>> target navigator.Please suggest where i was wrong?
>>
>>
>>
>> _______________________________________________
>>
>> QNX4 Community Support
>> http://community.qnx.com/sf/go/post95996
>> To cancel your subscription to this discussion, please e-mail
>> qnx4-community-unsubscribe@community.qnx.com
>>
>>
>>
>>
>> _______________________________________________
>>
>> QNX4 Community Support
>> http://community.qnx.com/sf/go/post96002
>> To cancel your subscription to this discussion, please e-mail
>> qnx4-community-unsubscribe@community.qnx.com
>>
>