Subramanian Somasundaram(deleted)
|
QNX SDP 6.6 BSP for Freescale i.MX6x SABRE SmartDevices Fails to Boot
|
Subramanian Somasundaram(deleted)
05/18/2017 6:57 PM
post117745
|
QNX SDP 6.6 BSP for Freescale i.MX6x SABRE SmartDevices Fails to Boot
I am new to QNX. I build the bsp as per BSP_User_Guide_Freescale_i.MX6x_SABRE_Smart_Devices.pdf. I renamed the image to
QNX-IFS. I configured the board switches as stated in the manual. However when I power the EVK up it throws this error
below. Can someone tell me what am I missing?
U-Boot 2014.04-rc3 (May 18 2015 - 09:56:04)
CPU: Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: MX6-SabreSD
DRAM: 1 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
*** Warning - bad CRC, using default environment
No panel detected: default to Hannstar-XGA
Display: Hannstar-XGA (1024x768)
In: serial
Out: serial
Err: serial
Net: FEC [PRIME]
Hit any key to stop autoboot: 0
mmc1 is current device
reading boot.scr
** Unable to read file boot.scr **
reading zImage
** Unable to read file zImage **
Booting from net ...
FEC Waiting for PHY auto negotiation to complete......... TIMEOUT !
BOOTP broadcast 1
BOOTP broadcast 2
BOOTP broadcast 3
BOOTP broadcast 4
BOOTP broadcast 5
|
|
|