Kushal Koolwal
|
ifs image size restrictions on x86?
|
Kushal Koolwal
04/23/2010 1:44 PM
post52576
|
ifs image size restrictions on x86?
I am building 6.3.2 .ifs images using buildfiles. I was happily building and booting .ifs images on my x86 target. I
decided to become little bit more adventurous and tried embedding photon support in my image. Before adding photon, my
image size was between 1MB to 2MB. After I added photon my image size went up over 3MB (3.3 MB to be exact). Now my
image won't boot on my board. My image hangs at:
Press F1-F4 to select drive or selection partition 1?1
Hit Esc for .altboot....................................................................................................
........................................................................................................................
..........................................................................
I found the following KB article:
http://www.qnx.com/support/knowledgebase.html?id=50130000000T0kf
and tried adding:
[image=8m]
but that didn't help too.
Any ideas how can I get around this size limitation?
|
|
|