foundry27 : Post

Forum Topic - unable to run qckp binary(quick copy) on my Target board: (2 Items)

View: as

basanth kumar kondasani

02/16/2010 1:58 AM

post47336

unable to run qckp binary(quick copy) on my Target board

Hi 
  I am not able to execute quick copy (qkcp) binary on Target board (ARM).However it is working fine on VMware(X86).

The following error which I am getting when I was running qkcp binary on Target Board.

copymetadata - MsgSend: Not supported
qkcp: ntfw - walker error

Please help me rectifying this issue.

Jeevan Mathew(deleted)

02/16/2010 5:18 PM

post47465

Re: unable to run qckp binary(quick copy) on my Target board

> Hi 
>   I am not able to execute quick copy (qkcp) binary on Target board (ARM).
> However it is working fine on VMware(X86).
> 
> The following error which I am getting when I was running qkcp binary on 
> Target Board.
> 
> copymetadata - MsgSend: Not supported
> qkcp: ntfw - walker error
> 
> Please help me rectifying this issue.
> 

Guessing :
Puhh, what arm is it ? (arm or arm 7)
What is the bsp you are using ?

however 

http://community.qnx.com/integration/viewvc/viewvc.cgi/trunk/utils/q/?root=coreos_pub&system=exsy1001

see qkcp source there and arm variants.

Hope this helps,
Jeevan

Return

The text you entered is not a valid object ID
More Information
Object IDs begin with an object prefix and end with a number. For example, if you enter
artf2345
the application will jump directly to an artifact with the ID artf2345. Some valid object prefixes are:
artf	for an artifact
doc	for a document
page	for a project page
topc	for a discussion topic
wiki	for a wiki page