foundry27 : Post

Forum Topic - SMC9000 driver issue: (2 Items)

View: as

yu zhe

09/03/2012 11:31 PM

post95342

hi, our old project used smc9000.so for MX chip, and it works fine. for now, we changed the reset pin and interrupt pin 
in the new release. and the sloginfo is like below:

unable to attach to pci server . no such file or directory.
couldn't initialize listen services: tcp
(address family not supported by protocol family)

what caused the errors above? besides, can u provide the driver source  of smc9000.so?

Hugh Brown

09/04/2012 8:41 AM

post95353

Re: SMC9000 driver issue

Well if you changed the interrupt, that sounds like the problem. What
interrupt are you using?




On 2012-09-03 11:31 PM, "yu zhe" <community-noreply@qnx.com> wrote:

>hi, our old project used smc9000.so for MX chip, and it works fine. for
>now, we changed the reset pin and interrupt pin in the new release. and
>the sloginfo is like below:
>
>unable to attach to pci server . no such file or directory.
>couldn't initialize listen services: tcp
>(address family not supported by protocol family)
>
>what caused the errors above? besides, can u provide the driver source
>of smc9000.so?
>
>
>
>_______________________________________________
>
>Networking Drivers
>http://community.qnx.com/sf/go/post95342
>To cancel your subscription to this discussion, please e-mail
>drivers-networking-unsubscribe@community.qnx.com

Return

The text you entered is not a valid object ID
More Information
Object IDs begin with an object prefix and end with a number. For example, if you enter
artf2345
the application will jump directly to an artifact with the ID artf2345. Some valid object prefixes are:
artf	for an artifact
doc	for a document
page	for a project page
topc	for a discussion topic
wiki	for a wiki page