Christophe Hannoyer
|
devn-micrel8841.so not working with QNX
|
Christophe Hannoyer
12/20/2011 11:08 AM
post90692
|
devn-micrel8841.so not working with QNX
Hello,
I get some problems with the driver devn-micrel8841.so and QNX 6.5 on PPC arch (MGT5200).
The driver is started with (with no other instance of io-packet running):
io-pkt-v4-hc -d micrel8841 verbose=3
Using the version of the driver devn-micrel8841.so provided with QNX 6.5 the device is detected, we are able for example
to detect the link status (we see if the cable is plugged or unplugged) but nothing go out on the network (checked with
a LAN analyzer directly connected on the target).
If on the same target (with the same QNX 6.5 image) I start io-packet with the version of the driver provided with QNX 6
.3.2 then in the case everything works perfectly.
In addition to this problem, we would like to set the MAC address of the board when we start the driver. If we start
with the option mac=xxx then all the devices of the system get the same MAC address (see attached logfile).
In the log file you have also the sloginfo when we start the driver and the pci -v of the system.
Best regards,
Christophe Hannoyer
|
|
|