Hi Jacek,

This is an error in hardware firmware. You can ignore it if the network 
works fine. Otherwise you need to contact hardware manufacturer (or 
reseller). As far as I know the Net.ether82557 driver uses only MAC 
address from EEPROM.

-- 
Respectfully,
Oleg

> Hi,
> 
> This is what I get when I start Net.ether82557 in verbose mode:
> Speedo (Lan:1) : Warning - EEPROM CRC Failure.
> 
> Is this warning danger or not ?
> Can I ignore this message ?
> 
> Here is my NIC:
> 
> Driver Slot 0:  Driver Pid 1073  Logical Net 1  Network Card: Ethernet/
> Speedo : 82557 C-Step Ethernet Controller
>     Vendor ID ........................ 0x8086
>     Device ID ........................ 0x1050
>     Subsystem ID ..................... 0x3013
>     Subsystem Vendor ID .............. 0x8086
>     Revision ......................... 0x2
>     Physical Node ID ................. 00032D 085B93
>     Media Rate ....................... 100Mb/s FDX
>     Mtu .............................. 1514
>     Hardware Interrupt ............... 10
> 
> 
> Regards,
> Jacek
> 
> 
> 
> _______________________________________________
> 
> General
> http://community.qnx.com/sf/go/post41684
>