hi, our old project used smc9000.so for MX chip, and it works fine. for now, we changed the reset pin and interrupt pin in the new release. and the sloginfo is like below: unable to attach to pci server . no such file or directory. couldn't initialize listen services: tcp (address family not supported by protocol family) what caused the errors above? besides, can u provide the driver source of smc9000.so?
Well if you changed the interrupt, that sounds like the problem. What interrupt are you using? On 2012-09-03 11:31 PM, "yu zhe" <community-noreply@qnx.com> wrote: >hi, our old project used smc9000.so for MX chip, and it works fine. for >now, we changed the reset pin and interrupt pin in the new release. and >the sloginfo is like below: > >unable to attach to pci server . no such file or directory. >couldn't initialize listen services: tcp >(address family not supported by protocol family) > >what caused the errors above? besides, can u provide the driver source >of smc9000.so? > > > >_______________________________________________ > >Networking Drivers >http://community.qnx.com/sf/go/post95342 >To cancel your subscription to this discussion, please e-mail >drivers-networking-unsubscribe@community.qnx.com