Hi Marcin:

A straight port of the urtwn driver source from NetBSD to QNX doesn't work. I had to do a raw port using the linux driver instead. Then ran into issues with device power-on initialization. Unsure if my embedded hardware is incapable of supporting module or a timing problem with codes. Realtek vendor support non-existent.

Recommendation: Unless you really need some capability of these new dongles, otherwise it might be just faster to go with devices that qnx already supports or opt for a linux distro instead. These new dongles work great on traditional windows and ubuntu...

fyi: I am no longer working on this problem anymore, my contract has already lapsed. Hope it helps.

B/R
Jim

On Mon, Mar 11, 2013 at 9:10 PM, Marcin Morawski <community-noreply@qnx.com> wrote:
Hi Jim,

Did You succeed with porting this RTL8192CU driver on QNX?
I have similar problem with WiFi USB dongle that runs on RTL8188CU QNX driver i couldn't find anywhere. I've finally stuck on your post and i thought Your experience in this matter might be helpfull. On netBSD page You've mentioned there is RTL8188CU driver added so this ported driver might work for me as well.

I would be gratefull for any help.

Regards,
Marcin.



_______________________________________________

Networking Drivers
http://community.qnx.com/sf/go/post99785
To cancel your subscription to this discussion, please e-mail drivers-networking-unsubscribe@community.qnx.com