U-Boot 2013.04-rc1-14237-g90639fe-dirty (Apr 13 2013 - 13:57:11) I2C: ready DRAM: 512 MiB WARNING: Caches not enabled NAND: No NAND device found!!! 0 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 *** Warning - readenv() failed, using default environment musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Peripheral mode controller at 47401000 using PIO, IRQ 0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Host mode controller at 47401800 using PIO, IRQ 0 Net: not set. Validating first E-fuse MAC cpsw, usb_ether Hit any key to stop autoboot: 0 gpio: pin 53 (gpio 53) value is 1 mmc0 is current device micro SD card found mmc0 is current device gpio: pin 54 (gpio 54) value is 1 SD/MMC found on device 0 reading uEnv.txt 147 bytes read in 5 ms (28.3 KiB/s) Loaded environment from uEnv.txt Importing environment from mmc ... Running uenvcmd ... Device: OMAP SD/MMC Manufacturer ID: 3 OEM: 5344 Name: SU08G Tran Speed: 50000000 Rd Block Len: 512 SD version 2.0 High Capacity: Yes Capacity: 7.4 GiB Bus Width: 4-bit reading ifs-ti-beaglebone.bin 79276484 bytes read in 8936 ms (8.5 MiB/s) ## Starting application at 0x81000000 ... DDR DPLL in Lock mode: DDR clock 400 Mhz [400/1] Disp DPLL in Lock mode: Disp clock 300 Mhz [300/1] MPU DPLL in Lock mode: MPU clock 550 Mhz [550/1] PER DPLL in Lock mode: PER clock 192 Mhz [960/5] CORE DPLL in Lock mode: M4 CORE clock 100 Mhz [1000/10] M5 CORE clock 125 Mhz [1000/8] M6 CORE clock 250 Mhz [1000/4] Not a BeagleBone?? CPU0: L1 Icache: 512x64 CPU0: L1 Dcache: 512x64 WB CPU0: L2 Dcache: 4096x64 WB CPU0: VFP-d32 FPSID=410330c3 CPU0: NEON MVFR0=11110222 MVFR1=00011111 CPU0: 413fc082: Cortex A8 rev 2 500MHz Loading IFS...done elf_map: 1M va=fe000000 pa=81000000 sz=00100000 elf_map: 1M va=fe000000 pa=81000000 sz=00100000 Header size=0x0000009c, Total Size=0x00000698, #Cpu=1, Type=4 Section:system_private offset:0x000001c8 size:0x00000068 syspage ptr user:fc404000 kernel:fc404000 cpupage ptr user:fc404d88 kernel:fc404d88 spacing:84 kdebug info:00000000 callback:00000000 boot pgms: idx=0 0) base paddr:81018000 start addr:fe049d48 ramsize:00000000 pagesize:00001000 Section:qtime offset:0x00000148 size:0x00000060 boot:00000000 CPS:00000000016e3600 rate/scale:41666666/-15 intr:68 flags:00000000 load:0 epoch:1970 rr_mul:0 adj count/inc:0/0 Section:callout offset:0x000000a0 size:0x00000048 reboot:fc404ba0 power:fc404bbc timer_load:fc404bdc reload:fc404c20 value:fc404c3c 0) display:fc404c5c poll:fc404c94 break:fc404ccc 1) display:00000000 poll:00000000 break:00000000 Section:cpuinfo offset:0x000001a8 size:0x00000020 0) cpu:413fc082 flags:c0000066 speed:000001f4 cache i/d:0/1 name:61 Section:cacheattr offset:0x00000658 size:0x00000040 0) flags:01 size:0040 #lines:0200 control:fc404698 next:255 1) flags:22 size:0040 #lines:0200 control:fc4046d8 next:255 Section:meminfo offset:0x00000698 size:0x00000000 Section:asinfo offset:0x00000318 size:0x000001c0 0000) ffffffff00000000-0000ffff00000000 o:0010 a:0064 p:2164335272 c:00000000 n:21 0020) ffffffff00000000-0000000000000000 o:0010 a:0064 p:2164335272 c:00000000 n:28 0040) 8fffffff00000000-0000002000000000 o:0017 a:0064 p:2164335272 c:00000000 n:36 0060) ffffffff00000000-0000ffff00000000 o:0010 a:0064 p:2164335272 c:00000000 n:21 0080) 8fffffff00000000-0000006000000000 o:0007 a:0064 p:2164335272 c:00000000 n:40 00a0) 85b9a9c300000000-0000000000000000 o:0005 a:0064 p:2164335272 c:00000000 n:71 00c0) 8101310f00000000-0000000000000000 o:0007 a:0064 p:2164335272 c:00000000 n:79 00e0) 85b9a9c300000000-0000000000000000 o:0007 a:0064 p:2164335272 c:00000000 n:87 0100) ffffffff00000000-0000ffff00000000 o:0010 a:0064 p:2164335272 c:00000000 n:95 0120) fe0a19e400000000-0000010000000000 o:0000 a:0064 p:2164335272 c:00000000 n:103 0140) 80007fff00000000-0000004000000000 o:0007 a:0064 p:2164335272 c:00000000 n:109 0160) 8000efff00000000-0000004000000000 o:0007 a:0064 p:2164335272 c:00000000 n:109 0180) 8100000700000000-0000004000000000 o:0007 a:0064 p:2164335272 c:00000000 n:109 01a0) 8fffffff00000000-0000004000000000 o:0007 a:0064 p:2164335272 c:00000000 n:109 Section:hwinfo offset:0x000002d0 size:0x00000048 0) size:3 tag:3(Group) isize:3, iname:0(hw), owner:65535, kids:1 12) size:3 tag:17(Bus) isize:3, iname:9(unknown), owner:0, kids:1 24) size:3 tag:3(Group) isize:3, iname:45(rtc), owner:12, kids:1 36) size:4 tag:54(Device) isize:4, iname:49(NONE), owner:24, kids:0 00 00 00 00 Section:typed_strings offset:0x00000230 size:0x00000028 off:0 type:5 string:'BeagleBone' off:16 type:2 string:'localhost' Section:strings offset:0x00000258 size:0x00000078 [0]'hw' [3]'Group' [9]'unknown' [17]'Bus' [21]'memory' [28]'below4G' [36]'ram' [40]'1to1' [45]'rtc' [49]'NONE' [54]'Device' [61]'Cortex A8' [71]'imagefs' [79]'startup' [87]'bootram' [95]'virtual' [103]'vboot' [109]'sysram' Section:intrinfo offset:0x000004d8 size:0x00000180 0) vector_base:00000000, #vectors:128, cascade_vector:7fffffff cpu_intr_base:00000000, cpu_intr_stride:0, flags:0000 id => flags:8000, size:003c, rtn:fc404764 eoi => flags:9000, size:0030, rtn:fc4047a0 mask:fc4047d0, unmask:fc404800, config:00000000 1) vector_base:00000200, #vectors:64, cascade_vector:0000000c cpu_intr_base:00000000, cpu_intr_stride:0, flags:0000 id => flags:8000, size:0048, rtn:fc404830 eoi => flags:9000, size:0038, rtn:fc404878 mask:fc4048b0, unmask:fc4048e0, config:00000000 2) vector_base:00000300, #vectors:32, cascade_vector:00000060 cpu_intr_base:00000000, cpu_intr_stride:0, flags:0000 id => flags:0000, size:0030, rtn:fc404910 eoi => flags:1000, size:002c, rtn:fc404940 mask:fc40496c, unmask:fc404990, config:00000000 3) vector_base:00000320, #vectors:32, cascade_vector:00000062 cpu_intr_base:00000000, cpu_intr_stride:0, flags:0000 id => flags:0000, size:0030, rtn:fc4049b4 eoi => flags:1000, size:002c, rtn:fc4049e4 mask:fc404a10, unmask:fc404a34, config:00000000 4) vector_base:00000340, #vectors:32, cascade_vector:00000020 cpu_intr_base:00000000, cpu_intr_stride:0, flags:0000 id => flags:0000, size:0030, rtn:fc404a58 eoi => flags:1000, size:002c, rtn:fc404a88 mask:fc404ab4, unmask:fc404ad8, config:00000000 5) vector_base:00000360, #vectors:32, cascade_vector:0000003e cpu_intr_base:00000000, cpu_intr_stride:0, flags:0000 id => flags:0000, size:0030, rtn:fc404afc eoi => flags:1000, size:002c, rtn:fc404b2c mask:fc404b58, unmask:fc404b7c, config:00000000 Section:smp offset:0x00000698 size:0x00000000 Section:pminfo offset:0x00000698 size:0x00000000 Section:mdriver offset:0x00000698 size:0x00000000 Section:boxinfo offset:0x00000698 size:0x00000000 Section:cpu offset:0x00000128 size:0x00000020 page_flush:fc404720 page_flush_deferred:fc404760 upte_ro:00000a6e upte_rw:0000087e kpte_ro:0000025e kpte_rw:0000005e mask_nc:0000004c ttb_attr:00000010 pte_attr=00000009 mmu_cr1:00c51878 set:0080387f clr:00000000 -> 00c5387f Jumping to QNX System page at phys:80011000 user:fc404000 kern:fc404000 Starting next program at vfe049d48 cpu_startnext: cpu0 -> fe049d48 VFPv3: fpsid=410330c3 coproc_attach(10): replacing fe079700 with fe078f8c coproc_attach(11): replacing fe079700 with fe078f8c Welcome to QNX Neutrino 6.5.0 SP1 on the Texas Instruments BeagleBone (ARMv7 Cortex-A8 core) - Board Starting MMC/SD driver... Path=0 - TI OMAP3 MMCHS target=0 lun=0 Direct-Access(0) - SD:3 SU08G Rev: 8.0 mount: Can't mount /mnt (type dos) mount: Possible reason: Invalid argument Process 6 (mount) exited status=1. starting I2C driver... starting WDT reset utility... changing thread parameters AM335X Watchdog: No timeout specified, using 2x kicktime = 30000 ms phy_base=0x44e35000 size=0x00000064 starting Board ID driver... stop timer Board ID header: ee3355aa name: A335BNLT version: 00C0 serial: 1516BBBK18F6 config: �������������������������������� Process 16394 (bdid-am335x) exited status=0. Setting OS Clock from on-board RTC Process 20490 (rtc) exited status=0. Starting USB OTG Host driver... Starting SPI driver... Starting network driver... Process 24590 (if_up) exited status=0. Process 28686 (ifconfig) exited status=0. starting devc-pty ... Starting inetd daemon ram_sim_args: Missing argument for 'capacity'Path=0 - target=0 lun=0 Direct-Access(0) - ram Rev: Process 36882 (dinit) exited status=0. Process 40978 (mount) exited status=0. Starting graphics driver Process 57364 (mount) exited status=0. Starting graphics driver1 Starting graphics driver2 # qconn