Lichun Zhu

I have a problem in getting SDIO on my new IMX6 solo lite board running qnx when ever i do a read using command 53 it is giving me CRC error with DMA interrupt set, interrupt status register value is 0x20000A meaning a CRC error.

First read using CMD53 is giving me this error all CMD 52 are working fine. Have been struggling with this issue from long. Please suggest me some solution.

Regards
Kaushik


On Thu, Apr 3, 2014 at 11:48 AM, kaushik choudhury <ikaushikc@gmail.com> wrote:
Lichun Zhu

Thanks for the response iam able to set 10 Little Endian Mode and things worked fine. 

Regards
Kaushik


On Wed, Apr 2, 2014 at 11:02 PM, Lichun Zhu <community-noreply@qnx.com> wrote:

5–4

EMODE

Endian Mode:

The uSDHC supports all four endian modes in data transfer. Refer to Data Buffer " for more details.

00 Big Endian Mode

01 Half Word Big Endian Mode

10 Little Endian Mode

11 Reserved

 

 

From: kaushik choudhury [mailto:community-noreply@qnx.com]
Sent: April-02-14 1:31 PM
To: ostech-core_os@community.qnx.com
Subject: Re: DMA on imx6 platform giving wrong values

 

Lichun Zhu 

 

Is this some thing related to configuring big endian and little endian on PROT_CTRL register if so can you please  let me known the specification which talk about bit 4 and 5 of PROT_CTRL. register. 

 

Regards

Kaushik

 

On Wed, Apr 2, 2014 at 7:16 PM, Lichun Zhu <community-noreply@qnx.com> wrote:

Did you set bit 4-5 of the PROT_CTRL register properly? Does PIO mode work? Do you need to do cache operation if the buffer is cacheable?


-----Original Message-----
From: Kaushik Choudhury [mailto:community-noreply@qnx.com]
Sent: Wednesday, April 02, 2014 9:03 AM
To: ostech-core_os
Subject: DMA on imx6 platform giving wrong values

Hi

Iam working on porting linux sdio driver on to QNX. For sending CMD53 i have created a virtual memory using MMAP and got the physical address of this mmap return virtual memory using function mem_offset.

The problem is when i have to do DMA read of 4 byte value using the physical address that i got above i get value in form of BIG ENDIAN.

Example in place of 1 i get 0x1000000.

The imx6 processor when executing CMD53 for read and write is expecting and giving me value in BIGENDIAN were as it is little ENDIAN in case of linux.

Please let me known is there anything wrong that iam doing or is this the right way it works.

Regards
Kaushik



_______________________________________________

OSTech
http://community.qnx.com/sf/go/post109748
To cancel your subscription to this discussion, please e-mail ostech-core_os-unsubscribe@community.qnx.com




_______________________________________________

OSTech
http://community.qnx.com/sf/go/post109753
To cancel your subscription to this discussion, please e-mail ostech-core_os-unsubscribe@community.qnx.com