You don't need to modify startup-bios, but you need to run mkifs to regenerate the boot image, then transfer that onto the image.

You'll need to become familiar with the docs for startup-bios and mkifs, and you'll have to locate the build file used for your current system.

On 2015-04-29 11:28 AM, community-noreply@qnx.com wrote:
Colin - thanks.  Do I need to rebuild startup-bios or is it called in a way that I can modify the args without a rebuild?  If I need to rebuild startup-bios, is that all I need to do (change, recompile and put it in /boot/sys) or ???  Any cautions?

From: "Colin Burgess" <community-noreply@qnx.com>
To: general-community@community.qnx.com
Sent: Wednesday, April 29, 2015 6:05:27 AM
Subject: Re: VM and memory

Try passing -x to startup-bios to enable PAE

On 2015-04-27 5:42 PM, Terry Laughlin wrote:
> Help.  I am using the canned QNX 6 for VM.  It is apparently set for 3G of memory.  When I up the available memory in VM, QNX still uses 3G.  Is there any easy way to bump the memory that QNX sees and ** uses **.  Thanks much.
>
>
>
> _______________________________________________
>
> General
> http://community.qnx.com/sf/go/post113748
> To cancel your subscription to this discussion, please e-mail general-community-unsubscribe@community.qnx.com





_______________________________________________

General
http://community.qnx.com/sf/go/post113753
To cancel your subscription to this discussion, please e-mail general-community-unsubscribe@community.qnx.com