Texas Instruments DRA446 Evaluation Module (EVM) Board Support Package#

This BSP supports the Texas Instruments DRA446 Evaluation Module (EVM). This board is also referred to as "Jacinto".

Note: For additional information about the Texas Instruments DRA446 BSP we recommend to read the articles: Getting Started with TI Jacinto BSP

Access to this BSP is granted on-demand, please first contact the QNX Community Management Group_

Releases#

QNX Neutrino 6.4.0#

QNX Neutrino 6.3.x#

DSPLink#

Features#

Some of these drivers are commented out in the default buildfile. To use the drivers in the target hardware, you'll need to uncomment them in your buildfile, rebuild the image, and load the image into the board.

QNX Neutrino 6.4.0 Change History#

Trunk#

• Same as QNX Neutrino 6.4.0 Texas Instruments DRA446 EVM BSP 1.0.0

1.0.0#

• Created from QNX Neutrino 6.3.2 Texas Instruments DRA446 EVM BSP version 1.0.0
• Built using the latest 6.4.0 toolchain
• Support for ARM11 enabled procnto
• Upgraded DSP Link to 1.40.05 patch3.3

QNX Neutrino 6.3.2 Change History#

1.0.0#

• Initial release under MEULA and Apache II
• Includes:
  • Audio
  • CAN
  • EIDE Block
  • DSP Link 1.40.05
  • Ethernet
  • Graphics
  • I2C
  • IPL
  • NAND
  • SD Block
  • Serial
  • SPI
  • Startup
  • USB OTG Host

Where to buy Hardware:#