TeamForge : Post

Forum Topic - help!!!!!!!Unable to access /dev/hd0:

View: as

Anu mohan m(deleted)

10/16/2021 3:34 AM

post121626

help!!!!!!!Unable to access /dev/hd0

I am trying to install QNX 6.3.0 on PC 
PC is equipped with SATA hard disk (1 tb  )with 7th gen mother board and I3 6th gen processor. 

It is able to load the software version and application but  while booting in routine mode it shows this error 
unable to acess "/dev/hdo"(2)
mount : can't mount /(type qnx4)
mount : possible reason : no such device or address
unable to start "mount" (2)
unable to start "ksh"(2)

Quires 
1.	Software version 6.3 is compactable with 7th gen mother board and I3 6th gen processor, if so how to resolve above 
error
2.	If it not compatible which processor and mother board can be used ?
 
Kindly quide 

Thanks in advance 
Anu Mohan M

Attachment:

WhatsApp Image 2021-10-14 at 7.16.25 PM (2).jpeg 67.18 KB

WhatsApp Image 2021-10-14 at 7.16.25 PM.jpeg 51.22 KB

Albrecht Uhlmann

10/19/2021 4:49 AM

post121628

Re: help!!!!!!!Unable to access /dev/hd0

Hello Anu,
we are unaware of any current hardware that supports QNX 6.3. To be honest, I am surprised to see that you got *that* 
far with the installation.

I think the Intel 945 chipset was one of the last that supports 6.3.

You could try to virtualize the system, which works pretty well if you can switch all communications to IP-based 
protocols.

Another approach would be a forward port to recent QNX versions.

Regards,
Albrecht

Return