|
Re: Multiple Interfaces in QNX 6.4.1
|
04/02/2024 9:41 PM
post122516
|
Re: Multiple Interfaces in QNX 6.4.1
|
|
|
|
Re: Multiple Interfaces in QNX 6.4.1
|
04/02/2024 9:42 PM
post122517
|
Re: Multiple Interfaces in QNX 6.4.1
> Hi,
>
> We have a computer with 2 voards.
> 1 of the CPU connects to the network using DHCP and it also connects to the
> other CPU using Serial over TCP communication.
>
> I am porting this project from 6.3.1.
> The earlier code was:
> The earlier code for having the network up for the CC project(Lower Board) was
> :
>
> io-net -dspeedo -dfd fd=/dev/ser1,mac=000102030405,ahdlc -ptcpip
>
> ifconfig en1 1.1.1.1 netmask 255.255.255.252
>
> For the MC project (Upper Board) it was:
>
> io-net -dspeedo -dfd fd=/dev/ser1,mac=000102030406,ahdlc -ptcpip
>
> ifconfig en1 1.1.1.2 netmask 255.255.255.252
>
>
>
> As we can see that there were two interfaces en0 and en1.
>
> Since we connect the lower board’s Ethernet port to the network so the lower
> board was getting 2 IP’s for 2 different interfaces.
>
> The interface en1 of the lower board was used to communicate with the upper
> board and the interface en0 was used to communicate with the network.
>
> But i dont know how can we have multiple interfaces in QNX 6.4.1.
> I could not see an appropriate answer when I searched through web
>
> Please Help.
>
> no
>
>
|
|
|