Well if you changed the interrupt, that sounds like the problem. What
interrupt are you using?




On 2012-09-03 11:31 PM, "yu zhe" <community-noreply@qnx.com> wrote:

>hi, our old project used smc9000.so for MX chip, and it works fine. for
>now, we changed the reset pin and interrupt pin in the new release. and
>the sloginfo is like below:
>
>unable to attach to pci server . no such file or directory.
>couldn't initialize listen services: tcp
>(address family not supported by protocol family)
>
>what caused the errors above? besides, can u provide the driver source
>of smc9000.so?
>
>
>
>_______________________________________________
>
>Networking Drivers
>http://community.qnx.com/sf/go/post95342
>To cancel your subscription to this discussion, please e-mail
>drivers-networking-unsubscribe@community.qnx.com