Marcin Morawski(deleted)
|
Re: QNX SDP 6.5.0 disk boot falilure on PCM-4153FZ2
|
Marcin Morawski(deleted)
01/05/2015 11:52 AM
post112826
|
Re: QNX SDP 6.5.0 disk boot falilure on PCM-4153FZ2
Hi Elena.
Thank you for your interest.
My CD contains QNX SDP 6.5.0 for x86 boards only. While trying to install it
an information appears on the screen that tere is not enough space on disk
(in my case: 1GB NAND flash accessed via EIDE interface).
I abandoned automatic installation idea and I have read manual about
building OS images.
After couple of days of fighting I eventually managed to build OS image and
transfered it to flash storage of PCM-4153. For now there are only few
components working like: console, eide driver and file system, serial ports,
network interface as well as some system commands (ls, pwd, cp, ifconfig
pidin etc.). The installed system is also accessed via LAN from Momentics
IDE which is installed on Windows host.
I have also attached PCM-3680I CAN interface card to PCM-4153, run its
driver and it is working too. I have achieved what I wanted namely
controlling Maxon motor with EPOS2 controller via CAN interface.
I have still much to learn with bilding OS images but first steps are behind
me
Kind regards,
Marcin.
|
|
|