Community/Discussion/QNX4 Community Support (EOL)/QNX 4.25 commands hang before exiting/List of Posts
 
Forum Topic - QNX 4.25 commands hang before exiting: (3 Items)
   
Update
Kevin Miller
06/06/2008 4:26 PM
post8853
QNX 4.25 commands hang before exiting   
We have a system in the field that shows a symptom that I have not seen before. If I type a command, e.g. "sin", the 
command executes immediately; however, after the list of processes has been printed, there is a long period, perhaps 15 
to 20 seconds, where nothing happens before the command prompt returns. Other commands, such as "ls", behave similarly. 
It seems that something is holding up the command's exit, but what it is is hard to say.

If anyone has any insight into this, I'd appreciate hearing about it.

Thanks,

Kevin
Hugh Brown(deleted)
06/09/2008 8:08 AM
post8871
RE: QNX 4.25 commands hang before exiting   
This sounds as though the node is looking for something on the network.
Are you using Fleet networking, and if so, does the node rely on other
resources on the network?


-----Original Message-----
From: Kevin Miller [mailto:kevin.miller@transcore.com] 
Sent: Friday, June 06, 2008 4:27 PM
To: qnx4-community
Subject: QNX 4.25 commands hang before exiting

We have a system in the field that shows a symptom that I have not seen
before. If I type a command, e.g. "sin", the command executes
immediately; however, after the list of processes has been printed,
there is a long period, perhaps 15 to 20 seconds, where nothing happens
before the command prompt returns. Other commands, such as "ls", behave
similarly. It seems that something is holding up the command's exit, but
what it is is hard to say.

If anyone has any insight into this, I'd appreciate hearing about it.

Thanks,

Kevin

_______________________________________________
QNX4 Community Support
http://community.qnx.com/sf/go/post8853
Kevin Miller
07/15/2008 5:32 PM
post10570
Re: QNX 4.25 commands hang before exiting   
This turned out to be a hardware problem.

Return