Community/Discussion/General/unable to run qckp binary(quick copy) on my Target board/List of Posts
 
Forum Topic - unable to run qckp binary(quick copy) on my Target board:
   
Update
basanth kumar kondasani
02/16/2010 1:58 AM
post47336
unable to run qckp binary(quick copy) on my Target board   
Hi 
  I am not able to execute quick copy (qkcp) binary on Target board (ARM).However it is working fine on VMware(X86).

The following error which I am getting when I was running qkcp binary on Target Board.

copymetadata - MsgSend: Not supported
qkcp: ntfw - walker error

Please help me rectifying this issue.
Jeevan Mathew(deleted)
02/16/2010 5:18 PM
post47465
Re: unable to run qckp binary(quick copy) on my Target board   
> Hi 
>   I am not able to execute quick copy (qkcp) binary on Target board (ARM).
> However it is working fine on VMware(X86).
> 
> The following error which I am getting when I was running qkcp binary on 
> Target Board.
> 
> copymetadata - MsgSend: Not supported
> qkcp: ntfw - walker error
> 
> Please help me rectifying this issue.
> 

Guessing :
Puhh, what arm is it ? (arm or arm 7)
What is the bsp you are using ?

however 

http://community.qnx.com/integration/viewvc/viewvc.cgi/trunk/utils/q/?root=coreos_pub&system=exsy1001

see qkcp source there and arm variants.

Hope this helps,
Jeevan

Return