Hello Armin. Please say, where you get this. In /proc ?????????
These are the interrupts of my host OS (Suse 12.1/ 32bit) mapped to
the interrupts of QNX 6.5) (-> virtualized version 6.5SP1
as provided by QSS !!
What host OS are you using ?
Could it be that the UDP packets are lost by the host OS ? ( Windows
?)
Are you using NAT or bridging with your guest OS (QNX) ?
Here are my results after a ftp transfer from the host to the guest:
# nicinfo
en0: AMD PCNET-32 Ethernet Controller
Physical Node ID ........................... 000C29 794934
Current Physical Node ID ................... 000C29 794934
Current Operation Rate ..................... 10.00 Mb/s
Active Interface Type ...................... UTP
Maximum Transmittable data Unit ............ 1514
Maximum Receivable data Unit ............... 1514
Hardware Interrupt ......................... 0xa
I/O Aperture ............................... 0x2000 - 0x207f
Memory Aperture ............................ 0x0
Promiscuous Mode ........................... Off
Multicast Support .......................... Enabled
Packets Transmitted OK ..................... 99
Bytes Transmitted OK ....................... 8003
Memory Allocation Failures on Transmit ..... 0
Packets Received OK ........................ 603
Bytes Received OK .......................... 251077
Memory Allocation Failures on Receive ...... 0
Single Collisions on Transmit .............. 0
Deferred Transmits ......................... 0
Late Collision on Transmit errors .......... 0
Transmits aborted (excessive collisions) ... 0
Transmit Underruns ......................... 0
No Carrier on Transmit ..................... 0
Receive Alignment errors ................... 0
Received packets with CRC errors ........... 0
Packets Dropped on receive ................. 0