Feed for discussion General in project QNX Community SDL Project.

post95932: CANT COPY .gif file from windows to QNX file system

kannan kumar(deleted) — Sun, 30 Sep 2012 13:43:41 GMT

i am trying to copy a gif file from windows to qnx file system

the problem i have noticed is change from GIF to gif.

the file for example as seen in windows system is "NAME.GIF"

when i copy to a usb and try viewing the same under QNX file system the file is seen as "NAME.gif"

hence my script to copy saying " cp NAME.GIF /home/Desktop"

fails always.

why is this change of "GIF" to "gif" happening.

whats the permanent solution

one solution will be to change it to small letters in my script

post94771: Display of bitmap file

Dennis Kellly(deleted) — Mon, 13 Aug 2012 11:39:18 GMT

Mike-

I am trying to use your port of SDL to qnx on F27.    It builds fine under 6.5.

A couple of tests seem to display fine to the screen – testdyngles and testgles.

The other tests – at best – display a cursor.  I was surprised I could not view a bitmap – even though it loads.

For example,  “./testwin sample.bmp”.   The bitmap never shows up, but the text on completion indicates no errors.

set fullscreen 640x480x16 mode

(video surface located in system memory)

loading picture: sample.bmp

testwin: setting colors

(video surface located in system memory)

Testwin: moving image

Testwin: fading out...

Testwin: fading in...

Testwin: fading over

Time 656 milliseconds

The Atom computer runs gma9xx driver (didn’t have any luck with SVGA).

Am I missing something?  Or did bitmap files never work?

TIA,

Dennis

post89935: Cant compile library on QNX

Felipe Santana — Tue, 08 Nov 2011 13:50:21 GMT

Hi all,

I have tried to follow the steps for building SDL on QNX.

But it was not successful. When I run the configure script, it gives

me the following message:

"configure: error: No acceptable C compiler found in $PATH"

Can anyone give some tips on that?

Thanks in advance!

Best regards

--

Felipe Santana

post89933: Cant compile on QNX

Felipe Santana — Tue, 08 Nov 2011 13:46:32 GMT

Hi,

I have tried to follow the steps for building SDL on QNX.

But it was not successful. When I run the configure script, it gives me the following message:

"configure: error: No acceptable C compiler found in $PATH"

Can anyone give some tips on that?

Thanks in advance!

Best regards