foundry27 : Post

Forum Topic - Application execution problem with OpenCV library on OMAP3530: (2 Items)

View: as

Eric Dong(deleted)

12/17/2012 8:58 AM

post98165

Application execution problem with OpenCV library on OMAP3530

Hello all,

I am debugging an opencv application on the OMAP3530 processor with QNX 6.5.0. I have managed to build the OpenCV 2.3 
library and compiled the program. When i tried to debug the application in the QNX Momentics IDE, a SIGBUS error 
happened which was shown in the screen shot I have attached. I guess there was some inherent link errors in the OpenCV 
library I built? How should I check where the error happened? Would like to seek your suggestions. Thank you.


Eric

Attachment:

debugWithLib.png 36.93 KB

Laurent COIGNOT(deleted)

10/16/2013 11:54 AM

post105970

Re: Application execution problem with OpenCV library on OMAP3530

Hi would you please kindlyy describe how you compiled openCV for your target please ?
It would help me to do the same with my iMX6 processor
thanks in advance

Return

The text you entered is not a valid object ID
More Information
Object IDs begin with an object prefix and end with a number. For example, if you enter
artf2345
the application will jump directly to an artifact with the ID artf2345. Some valid object prefixes are:
artf	for an artifact
doc	for a document
page	for a project page
topc	for a discussion topic
wiki	for a wiki page