Hi, everyone!

I'm not sure if this is the right place to ask, but can you help me with the following:

I'm trying to run the 'QNX Smart Energy Reference Design' on Beagleboard rev. C3.
How to get the mouse running in this project? I connect the Beagleboard via a USB hub connected to the USB OTG port 
which powers the board. I also connect the serial port to have a console. Unfortunately the mouse and keyboard attached 
to the hub are dead.
Here is the log from the start-up procedure:

------------ start-up ------------
Texas Instruments X-Loader 1.4.4ss (Jul 28 2010 - 16:59:13)
Beagle Rev C1/C2/C3
Reading boot sector
Loading u-boot.bin from nand


U-Boot 2009.01-dirty (Feb 19 2009 - 12:22:31)

I2C:   ready
OMAP3530-GP rev 2, CPU-OPP2 L3-165MHz
OMAP3 Beagle board + LPDDR/NAND
DRAM:  256 MB
NAND:  256 MiB                                                                  
MUSB: using high speed                                                          
In:    serial                                                                   
Out:   serial                                                                   
Err:   serial                                                                   
Board revision C                                                                
Serial #0dc6000300000000040323090c00d011                                        
Hit any key to stop autoboot:  0                                                
reading beagle.ifs                                                              
                                                                                
1985040 bytes read                                                              
## Starting application at 0x80200000 ...                                       
CPU0: L1 Icache: 256x64                                                         
CPU0: L1 Dcache: 256x64 WB                                                      
CPU0: L2 Dcache: 4096x64 WB                                                     
CPU0: VFP 410330c1                                                              
CPU0: 411fc083: Cortex A8 rev 3 500MHz                                          
                                                                                
System page at phys:80011000 user:fc404000 kern:fc404000                        
Starting next program at vfe047044                                              
cpu_startnext: cpu0 -> fe047044                                                 
VFPv3: fpsid=410330c1                                                           
coproc_attach(10): replacing fe074a20 with fe07426c                             
coproc_attach(11): replacing fe074a20 with fe07426c                             
Welcome to QNX Neutrino 6.4.3 on the Texas Instruments OMAP3530 (ARMv7 Cortex-Ad
starting I2C driver...                                                         
# Setting date to 200905010000.00                                               
                                                                                
===============================================                                 
QNX Smart Energy Panel                                                          
===============================================                                 
Starting USB services...                                                        
Was c5387f = A-bit set  U-bit set                                               
Now c5387d = A-bit not-set  U-bit set                                           
Starting HID services...                                                        
Starting ETFS...                                                                
Starting PPS services...                                                        
        io-media-generic                                                        
Starting Network services...                                 ...