Hi Klaus,

Unfortunately, the Dev32.ser can't access to registers via memory. It uses I/O 
ports only.

-- 
Respectfully,
Oleg

> Hello QNX masters,
> 
> I have a problem in the startup of the Dev32.ser.
> 
> Up to now I was using a PCI 4xserial card and everything was fine.
> Now I'm testing the PCIe card from the same vendor and dont know how to 
start the Dev32.ser.
> There is no output in show_pci for an IO range. Only information for Mem.
> The same info I get booting linux and using lspci. But in Linux there is the 
standard serial driver module "serial" used.
> 
> Is there a possibility to use the Mem info in the start of the Dev32.ser?
> 
> br,
> Klaus 
> 
> 
> 
> _______________________________________________
> 
> General
> http://community.qnx.com/sf/go/post89683
>