If you specify pci=0xX, the driver will only start on one interface. If you
remove the pci=0xX from the command line, all interfaces will be started.



On 11-03-23 11:46 AM, "William Luo" <community-noreply@qnx.com> wrote:

> I have 3 of RTL8139C+ on one PCI bus. The PCI number are line up with 0x0,
> 0x1, and 0x2. Each card can load properly with:
> io-net -d rtl pci=0xX -p tcpip
> 
> But I can't make all three cards working at the same time. The console freezes
> when I load more than 1 card at the same time. Is this a driver issue? or NIC
> EEPROM issue?
> 
> 
> 
> 
> _______________________________________________
> 
> General
> http://community.qnx.com/sf/go/post84213
> 
> 

-- 
Hugh Brown                      (613) 591-0931 ext. 2209 (voice)
QNX Software Systems Ltd.        (613) 591-3579           (fax)
175 Terence Matthews Cres.       email:  hsbrown@qnx.com
Kanata, Ontario, Canada.
K2M 1W8