For ARM Beagleboard (DM3730), Beaglebone Black or Pocket Beagle (AM335x). Running QNX 6.5 on Beagleboard or 6.6 on the last two. Does this driver exist? If not, how much work is required to make it work? The critter works on Linux on those boards. Here a link to the actual device that I have in hand. https://www.amazon.com/Realtek-RTL8192AU-Wireless-Adapter-Antenna/dp/B078NSSM7W Any help is greatly appreciated. Thanks, Todd
AFAIK, we have no intention to support this device. It would require several months of development. On 2019-05-31, 6:17 PM, "Todd Peterson(deleted)" <community-noreply@qnx.com> wrote: For ARM Beagleboard (DM3730), Beaglebone Black or Pocket Beagle (AM335x). Running QNX 6.5 on Beagleboard or 6.6 on the last two. Does this driver exist? If not, how much work is required to make it work? The critter works on Linux on those boards. Here a link to the actual device that I have in hand. https://www.amazon.com/Realtek-RTL8192AU-Wireless-Adapter-Antenna/dp/B078NSSM7W Any help is greatly appreciated. Thanks, Todd _______________________________________________ Networking Drivers http://community.qnx.com/sf/go/post119714 To cancel your subscription to this discussion, please e-mail drivers-networking-unsubscribe@community.qnx.com
Thanks. Is there a current list of supported wifi chipsets? The ones that are installed with QNX6.5 are really old Ralink chipsets. I did find a WiLink8 driver. Will try to find an appropriate device to try it out.
If you are looking for USB WiFi under 6.5.0, then the only ones are the old Ralink etc. The Wilink8 driver isn't a USB driver. On 2019-06-05, 1:17 PM, "Todd Peterson(deleted)" <community-noreply@qnx.com> wrote: Thanks. Is there a current list of supported wifi chipsets? The ones that are installed with QNX6.5 are really old Ralink chipsets. I did find a WiLink8 driver. Will try to find an appropriate device to try it out. _______________________________________________ Networking Drivers http://community.qnx.com/sf/go/post119728 To cancel your subscription to this discussion, please e-mail drivers-networking-unsubscribe@community.qnx.com
Yeah. I have a board design based upon the Octavo AM335x in development. We have provision for SDIO for the WiLink8. Short term I need a USB solution.
