This is the wrong conference. You should post this on the QNX4 conference.




On 2014/6/26, 7:46 AM, "John Rallis" <community-noreply@qnx.com> wrote:

>I bought a realtek 8019 ISA card to replace a faulty EN2000 as i know
>they work with the same driver.
>
>I also used its DOS configuration utility to setup the same IRQ/IO/MAC as
>the faulty card so i don't need to replace any configuration.
>
>The machine loads with no errors, driver loads fine and the TX light on
>the card starts to blink as it receives data from the other nodes. (it's
>a thinnet bus network)
>
>The problem is that this node does not connect to the QNX network. I will
>give you some troubleshooting command results:
>sin net -> shows only itself
>netmap -> is correct and same with the other nodes but in the "Last Fail
>TX Time" it seems to fail every 10 seconds
>netinfo -l -> the card configuration data is correct but all the TX and
>RX fields are 0 as though it doesnt transmit or receive anything
>netinfo -> every few lines i see errors 33 and 7 with a message "lan hang
>during TX"
>
>The only thing that differs from the other nodes is that this one carries
>2 more unused licenses, but those where installed by someone else and the
>license disks don't exist any more.
>
>Is the Lan card faulty or is there a license mismatch? If it's a license
>problem can i remove those 2 licenses by just deleting the license files
>or is there more to it?
>
>I really appreciate all your help!
>
>
>
>_______________________________________________
>
>Networking Drivers
>http://community.qnx.com/sf/go/post110869
>To cancel your subscription to this discussion, please e-mail
>drivers-networking-unsubscribe@community.qnx.com