My Development Environment Host: Ubuntu 12.0.4 Qnx: SDP 6.6 Target: iMx6 Sabre Auto/AI I have booted up the board with QNX Neutrino. I have setup serial connection between my PC and board. I could run shell commands on Minicom. When I give "ifconfig" it always show me inet as 0.0.0.0. Is this the required output or it should give a ip automatically detected from Host. Should I manually set up the IP using ifconfig eno <myIP>
Yes - call "ifconfig xx0 <myIP>/24" where "xx0" is the interface. Don't forget to add "/24" to set a network mask for the interface - in this case 255.255.255.0 (24-bits) Alternately, you can start "dhcp.client" - but one of these methods must be utilized before the interface is usable.
Thanks for the clarification Dennis Kelly