Dear QNX team,

I enabled the EEPROM write functinality in QNX atheros driver and I ported diag/eeprom utility. 

It works very well but I found a little problem. 
If I chaged the "Target_Power_Start_Location" in atheros register 0xC5 with the value which is incorrect, io-pkt fails 
to load atheros driver at the next booting cycle. 

Because EEPROM cannot be re-writeen without atheros driver, it could not be recovered.!! ( If I connect this corrupted 
wifi module to desktop and run ART.exe program then ART program automaticlly detect that the calibration value is 
invalid and fix it to default value(0x0182)

I think, even though the calibration value is invalid, driver should be loaded correctly doesn't it? 

Please let me know whether QNX team could fix this issue. 

Thanks,
Dooeui