AX88772B is the latest offering from ASIX for a usb to 10/100 ethernet chip.

This chip is smaller and has extended temperature range.   We would like to incorporate it in our product that is based 
on QNX 6.5.0

QNX has two drivers that support asix chips but I tried both with an AX88772B dongle and none work.

Are there any command line options what will make this work?

Here is what I have now:

io-pkt was run with -ptcpip option
 
After I insert the dongle I issue

mount -Tio-pkt /lib/dll/devn-asix.so


Here is what usb -v shows

USB 1 (EHCI) v1.10, v1.01 DDK, v1.01 HCD
    Control, Interrupt, Bulk(SG), Isoch(Stream), High speed

Device Address             : 1
Upstream Host Controller   : 1
Upstream Device Address    : 0
Upstream Port              : 0
Upstream Port Speed        : High
Vendor                     : 0x0b95 (ASIX Elec. Corp.)
Product                    : 0x772b (AX88772B)
Device Release             : r0.01
Class                      : 0xff (Vendor-specific)
Subclass                   : 0xff
Protocol                   : 0x00
Max PacketSize0            : 64
Configurations             : 1
  Configuration            : 1 (0)
    Attributes             : 0xa0 (Bus-powered, Remote-wakeup)
    Max Power              : 200 mA