Hi,

I have installed QNX 6.4.1, and downloaded the BSP
"bsp-freescale-i.mx35".

The processor used is I.mx356. In this project it required the graphical
interface development.

1.Please let me know how to load the BSP image to target.



Since im new to QNX, please let me know what target to be used for the
project using I.mx356 processor. The guide of how

 HMI interacts with the terminal mode concept.



2.Please let me know how can i project an image and manage the fonts?







Thanks  & Regards

Jyothi




Please do not print this email unless it is absolutely necessary.

The information contained in this electronic message and any attachments to this message are intended for the exclusive 
use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended
 recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy
 all copies of this message and any attachments.

WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for 
the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.

www.wipro.com