Hi,

I am having trouble reconnecting to my QNX target, after pulling the serial cable and then plugging it in again.

I am using windows and hyper terminal.

I have two different behaviors, depending on the QNX version I am using.

On QNX 6.3: while reconnecting the serial cable, I can see the output on hyper-terminal, but I can't input anything.

On QNX 6.5: while reconnecting the serial cable, there is no Output visible nor Input possible.

Term is configured as followed: TERM=qansi
I tried vt100/ansi/wansi settings on hyper terminal.

The only way to make it work again, is to reset QNX(However, the bug I am trying to analyze will then disappear).

*** The reason behind this is the following scenario: A tester complains that she has a problem with a device, and in 
order to debug it, I would like to connect with a serial cable.  ***


Thank you for your help,
Doron Hirsch.