satyendra marni
02/01/2008 4:59 AM
post4723
|
I have installed QNX neutrino for separate system.After the installation it asked for reboot the system. I have rebooted
. At the last step it is failed to open www.qnx.com site.And if I have given ifconfig command it is showing only lo0 (It
is not yet all showing en0).
How can I get en0 there?
Note: I am not using any VMware system. I am using separate system for running QNX neutrino kernel.
I am using broadcom corporation network. It is using tigon3 driver.Is it related to any network driver settings?
If I went through Launch->configure->TCP/IP configuration I didn't find any device tab there.
Please help me on this issues.
Thanks in advance.
Satyendra.M
|
|
|